Parallel Port Relay Interface
Computer circuits

Parallel Port Relay Interface

By internum


Here is an example of controlling a relay from the PC's parallel printer port (LPT1 or LPT2).

Here is an example of controlling a relay from the PC's parallel printer port (LPT1 or LPT2). The 7.5K resistor is connected to one of the data output lines (D0-D7) and a common connection is made from the negative side of the power supply to one of the port ground pins (18-25). Data is inverted by the 3904 transistor so that writing a "0" to the base address will energize any relays connected to D0-D7 and a "255" will reset them. You may need to try all three base addresses to determine the correct address for the port you are using but LPT1 is usually at Hex 0378. The QBasic "OUT" command can be used to send data to the port. OUT, &H0378,0 sets D0-D7 low and OUT, &H378,255 sets D0-D7 high.

Parallel Port Relay Interface circuit
Parallel Port Relay Interface circuit

1688 19 September 2009

See also:

Driving Stepper
M1 is a stepper taken from an old disk drive. There are five pins, i.e., common, coil 1, 2, 3 and 4. Resistance measured between common pin and each coil is about 75 Ohms. Driving current for each coil is then needed about 60mA at +5V supply. A darlington
Monitor Splitter
A Simple Splitter Driving Two (or even more) PC Monitors.
Connecting Dump Terminal
Some applications may not need user display and key interface, dump terminal is an alternative way for program setting, displaying user interfacing command.

Search